21_4.Cleaning Glass Parts; 21_5.Cleaning The Parts In Stainless Steel; 21_6.Cleaning Aluminium Parts; 21_7.Inspection Of The Parts - Arneg Coimbra 2 VCA Serie Manual De Instalacion Y Uso

Coimbra 2
VCA-VPA-VCB-SELF-H125
English
If any ice has formed, contact a qualified refrigeration technician for assistance.
The honeycomb must be reassembled at the same angle.

21_4.Cleaning glass parts

DO NOT use hot water on cold glass surfaces; the glass could crack and
injure the operator.
DO NOT use rough or abrasive materials or metal scrapers that could scratch
the glass surfaces
DO NOT use dirty cloths
Use a soft cloth with a neutral detergent or soap and lukewarm water (max
30°C).
Immediately remove all traces of water and detergent with a dry cloth in order
to prevent marks from forming and to prevent liquid from reaching the
gaskets, frame, or the glass door hinges.

21_5.Cleaning the parts in stainless steel

Certain situations can cause the formation of rust on the surfaces in steel:
iron remains left on damp surfaces, limestone, chlorine or ammonia based
detergents not rinsed properly, food incrustations or residues, salt-saline solutions,
dry residues of evaporated liquids.
Recent stains and rust:
clean with shampoo or neutral detergents, using a sponge or a rag. When finished,
eliminate any detergent residue, rinsing abundantly and thoroughly drying the
surfaces.
Old stains and rust:
use chemical substances on the stainless steel that contain 25% of nitric acid or
similar substances.
Die-hard stains and rust:
sandpaper or polish with a stainless steel brush. After this operation, wash with
detergents and carefully dry. This intervention may however cause scratches to the
surfaces due to the abrasive cleaning method.

21_6.Cleaning aluminium parts

DO NOT use acid or alkaline detergents (e.g. bleach) which could corrode the
surfaces
DO NOT use rough or abrasive materials or metal scrapers that could scratch
the aluminium surfaces
DO NOT use steam cleaning equipment
DO NOT use dirty cloths
Use a soft cloth with a neutral detergent or soap and lukewarm water (max 30°C).
Immediately remove all traces of water or detergent using a dry cloth in order
to prevent marks from forming.
All the cleaning operations, including the disinfection, the rinse and the drying
must be performed diligently, eliminating any water or detergent residue so as to
avoid the spread of bacteria harmful to health. Parts left to dry with detergent or
disinfectant residues may get damaged.
Remove any element from the pavement such as: sponges, rags, detergent or
water residues that may cause accidental slipping and falls.

21_7.Inspection of the parts

Once cleaning, disinfection, rinse, and drying operations have been completed,
accurately check that all the parts are perfectly clean and dry and that they are not
damaged or excessively worn out and, if need be, replace them.
Reassemble the completely dry elements and restore electrical power supply. Once
the internal operating temperature has been reached, it is possible to load the products
to be displayed in the cabinet.
38 05060143 00 10/04/2013