Stanley Bostitch RN46 Especificaciones Técnicas página 5

SAFETY INSTRUCTIONS
IMPORTANT READ CAREFULLY: It is important that all operators read and understand all sections of this
Tool Technical Data manual and the separate Safety and Operating Instruction Manual which come with
this tool. Failure to do so could result in you or others in the working area to be seriously injured.
WARNING! Eye protection in accordance with 89/686/EEC, and with equal or greater grade than defined
in EN166 should be used. However all aspects of operators work, environment and other type/s of machinery being used,
should also be considered when selecting any personal protection equipment. Note: Non-side shielded spectacles and
face shields alone do not provide adequate protection.
WARNING! To prevent accidental injuries:
● Never place a hand or any other part of the body in fastener discharge area of tool.
Never point tool at yourself or anyone whether it contains fasteners or not.
●
● Never engage in horseplay.
● Never pull the trigger unless the nose is directed towards the work.
Always handle the tool with care.
●
● This tool is intended to be used for fastening materials such as plasterboard, roofing felt and vapour barriers to wood
in construction applications. DO NOT USE for fastening harder materials which could cause buckling of the fasteners
and damage to the tool. If you are unsure of the suitability of this tool for certain applications, please contact your
local sales office.
● Do not pull the trigger or depress the trip mechanism whilst loading the tool.
● To prevent accidental actuation and possible injury, always disconnect air supply.
1. Before making adjustments. 2. When servicing the tool. 3. When clearing a jam. 4. When tool is not in use. 5. When
moving to a different work area, as accidental actuation may occur, possibly causing injury.
● Read the additional Safety & Operating instructions booklet before using tool.
● Do not use oxygen and combustible gases as an energy source for pneumatically operated tools.
●
The operation of this tool can cause sparks and act as a source of ignition for flammable fuels and gases.
IMPORTANT! RN46DW Models:
The RN46DW tool comes fitted with a nail steering guide for precise driving and placement of nails (Fig 1).
1. Open the magazine: Pull down on the latch and swing the door open. Swing magazine cover open. (Fig 2)
2. Check adjustment: the nailer must be set for the length of nail to be used. Nails will not feed smoothly if the magazine is
not correctly adjusted.
To change the setting:
a) The magazine contains an adjustable nail platform on which the nail coil rests. The nail platform can be adjusted up and
down to two nail settings. To change settings pull up on the post and twist to the correct step. (Fig 3)
b) 38, 45 mm. nails: use bottom setting
c) 19, 22, 25, 32 mm. nails use top step.
3. Load the coil of nails: (Fig 4)
Place a coil of nails over the post in the canister. Uncoil enough nails to reach the feeder pawl and place the second nail
between the teeth of the feeder pawl. The nail heads fit in slot on the feeder pawl.
4. Close the door/magazine cover: Swing the door/magazine cover closed. Check that latch engages. (if it does not
engage, check that the nail heads are in the slot on the nose).
Note: Use only fasteners recommended by Bostitch for use in Bostitch tools or nails which meet Bostitch specifications.
LOCK-OUT MECHANISM
This tool is equipped with a Lock-Out mechanism, which is activated when the magazine becomes empty. This indicates to
the operator that reloading is necessary. The tool may not actuate when the Lock-Out is engaged, as shown. (Fig 5)
All manuals and user guides at all-guides.com
GB