Dyna-Glo DGY784BDP Manual Del Usuario página 10

ASSEMBLY INSTRUCTIONS
3. Attach the top damper.
CAUTION: This unit is HEAVY! Do not
attempt this step without assistance!
Close the two doors. With the assistance of
a helper, stand the unit upright on its legs on
a firm and level surface. (Make sure that the
burner/control unit and legs are attached). Open
the upper door. Position the top damper (H)
with control arm to the right as shown and align
the screw holes of the damper by placing it
up through the inside of the smoker body (I).
Attach the damper (H) by using 4 screws (AA).
Securely tighten with a Phillips screwdriver.
DO NOT ATTACH BY PLACING THE BOTTOM
OF THE DAMPER (H) ON TOP OF THE
SMOKER BODY (I)
Hardware Used
AA
M6x12 Screw
4. Install the cooking grate supports.
Insert the cooking grate supports (Q) into the
corresponding holes on rack of the shelf inside
the smoker body (I) from the bottom up.
NOTE: There are 8 positions to install the
cooking grate supports. The cooking grate
supports can be installed into positions
according to the need of the owner.
3
x4
4
9
AA
I
H
Control
arm
I
Q