Dyna-Glo DGY784BDP Manual Del Usuario página 12

ASSEMBLY INSTRUCTIONS
7. Attach the door locking brackets.
Align the door locking bracket (G) holes with
the holes on the upper right side of the smoker
body (I). Note: slots on the brackets (G) must
be facing up. Thread 2 screws (AA) through the
holes in the door locking bracket and into the
threaded holes of the smoker body (I). Tighten
the screws (AA) using a Phillips screwdriver.
Repeat on lower right side.
Hardware Used
AA
M6x12 Screw
8. Attach the door handles.
Slide door handle (P) through brackets
in upper door. Using pliers, slide a spring clip
(CC) over the groove in the door handle as
shown. Repeat on bottom door.
Make sure both of the spring clips are securely
attached in the grooves of the handles.
Hardware Used
CC
Spring Clip
9. Install the wood chip box and lid.
Slide the wood chip box (C) onto the lowest
cooking grate supports inside the smoker body
(I) and put the wood chip box lid (D) on top.
7
x4
8
x2
9
11
I
G
AA
P
I
D
CC
C