Floor Installation - Rubbermaid 5L40 Manual Del Usuario

2.0 Floor Installation

A
a.
Using a rubber mallet and
screwdriver, punch out
the screw holes along
the connection edge
of both Repeat
Floors (B)
.
c.
Using a rubber mallet and screwdriver, knock out the
tabs for the door hinge, two places on Front Floor (A).
B
B
B
B
A
b.
Using a utility knife, cut the long side of each wall slot tab and
then use a rubber mallet and screwdriver to knock it out:
• 4 places on Front Floor (A)
• 4 places on Repeat Floor (B): middle location
• 8 places on Repeat Floor (B): rear location
6
1.
2.
B
B
A