BALDR B0389WST2H2-V1 Manual De Usuario página 13

MAX AND MIN RECORD
1.Press " " to check maximum and minimum temperature and
SET/MEM
humidity, the value will display for 5 seconds.
2.Press " " button second time to check the minimum temperature
SET/MEM
and humidity, the value will display for 15 seconds.
3.Press " " button third time will return to standard mode
SET/MEM
4.When in max record or min record display mode,press and hold the
" " button to clear the max and min record
SET/MEM
5. Normally, the Max and Min record will update every 24 hours at 0:00.
TEMPERATURE
1. After power on ,the indoor temperature will display automatically, it will
update reading each 30 seconds and start to receive outdoor signal
which lasts for max 3 minutes.
2. Indoor temperature display range:-10℃~ 50.0℃(14℉~122℉); for
temperature lower than -10℃(14℉),the reading will be :"LL.L"; for
temperature higher than +50℃(122℉),the reading will be :"HH.H".
3. Outdoor temperature display range :-40℃~60℃(40℉~140℉); for
temperature lower than-40℃(40℉),the reading will be :"LL.L"; for
temperature higher than +60℃(140℉),the reading will be :"HH.H".
4. Arrow indication for temperature changes:
will display when the reading increase by 1℃ within one hour or
compared with last reading
will display when the reading decrease by 1℃ within one hour or
compared with last reading.
5.Accuracy: For temperature between 0℃~50℃(32℉~122℉),the
accuracy is ±1℃,if out of this range the accuracy will be ±2℃.
Temperature resolution is 0.1 ℃(0.1℉).
Remark: The reading will be more accurate standing still for half an hour
after power on
OPERATION GUIDELINE
13