DBI SALA Vertical Lifeline Instrucciones De Uso página 8

5.2 INSPECTION STEPS:
Step 1. Inspect lifeline hardware (snap hooks, ferrules, thimbles, etc.). These items must not be
damaged, broken or distorted. These items must be free of sharp edges, burrs, cracks,
worn parts, or corrosion. Hook gates must move freely and lock upon closing.
Step 2. Inspect the lifeline per the following:
SYNTHETIC ROPE: Inspect rope for concentrated wear. Material must be free of frayed
strands, broken yarns, cuts, abrasions, burns, and discoloration. The rope must be free
of knots, excessive soiling, paint build-up, and rust staining. Rope splices must be tight,
with fi ve full tucks, and thimbles must be held fi rmly by the splice. Check for chemical
or heat damage; indicated by brown, discolored, or brittle areas. Check for ultraviolet
damage; indicated by discoloration and splinters and slivers along the rope surface. All
of the above factors are known to reduce rope strength. Damaged or questionable rope
should be replaced.
WIRE ROPE: Inspect entire length of wire rope. Always wear protective gloves when
inspecting wire rope. Inspect for broken wires by passing cable through gloved hands,
fl exing the rope every few inches to expose breaks. Broken wires can be removed by
bending the wire back and forth parallel to the rope length. Do not pull broken wires
out of the rope. Replace the wire rope if there are six or more randomly distributed
broken wires in one lay; or three or more broken wires in one strand in one lay. A "lay"
of wire rope is the length of wire rope it takes for a strand (the larger group of wires) to
complete one revolution along the rope. Replace the wire rope if there are broken wires
within one inch of the swages at either end of the assembly. Wire rope should be free of
corrosion.
Step 3. Inspect labels. All labels must be present and fully legible. See Section 9.
Step 4. Inspect each system component or subsystem according to manufacturer's instructions.
Step 5. Record the inspection date and results in the inspection log in Section 10.
5.3 If inspection reveals an unsafe or defective condition, remove equipment from service and
destroy, or contact an authorized service center for repair.
6.0 MAINTENANCE, SERVICING, STORAGE
6.1 Clean the lifeline with water and a mild detergent. Wipe hardware dry with a clean, dry cloth and
hang to air dry. Do not force dry with heat. An excessive build-up of dirt, paint, etc. may prevent
the lifeline from working properly, and in severe cases, weaken the rope.
6.2 Additional maintenance and servicing procedures must be completed by and authorized service
center. Authorization must be in writing. Do not disassemble this equipment.
6.3 Store the lifeline in a cool, dry, clean environment, out of direct sunlight. Avoid areas where
chemical vapors may be present. Thoroughly inspect the lifeline after extended storage.
8