Ce Declaration Of Conformity - Beninca DA.SO4 Guia De Inicio Rapido

The cabinet "DA.SO4" can be used to control power motors not greater than 20W.
Extension module DA.E
(1,2) Motor = Output, 24VDC motor
(3,4) P.P. = Input, control push button
Operating mode "open – close"
Trimmer P.M. = Adjustment of current limiter activation threshold
Important: Before inserting or replacing the cards "DA.E", cut-off power supply to the basic board.
Check that the connectors are correctly aligned before powering the circuit.
Mother board
(1,2) 230VAC = Input, power supply 230VAC - 50/60Hz
(3,4) 24VDC = Output, auxiliary 24VDC – Max consumption 1A ("3" negative, "4" positive)
(5,6) Antenna = Input, antenna for radio receiver.
J1,J2,J3,J4 = Connectors for control cards DA.E.
The cards are inserted at random.
Cut-off power supply to the mother board before inserting or removing the various cards.
J5 = Connector for battery charging card DA.RB.
Connect the negative pole of the battery to terminal "0V" and the positive to terminal "+24V";
it is not necessary to connect the intermediate terminal "+12V".
J6,J7,J8 = Channel selection of the radio receiver towards the connectors J1, J2, J3, J4.
Example: To connect the 1
in correspondence with column No. 3.
Four-channel radio receiver: in a four-channel receiver, each channel must be connected directly to inputs
"P.P." of the modules DA.E to be controlled. Selections J6, J7, J8 are valid only if a receiver connected to
connector JRX is used.
Declaration in accordance with Directives 2004/108/CE (EMC); 2006/95/CE (LVD)
The Manufacturer:Automatismi Benincà SpA
Address:Via Capitello, 45 - 36066 Sandrigo (VI) - Italy
Declares that the product:
DA.SO4
conforms with the requirements of the following EC Directives:
• DIRECTIVE 2004/108/CE OF THE EUROPEAN PARLIAMENT AND COUNCIL, 15 December 2004, in rela-
tion to the harmonisation of the legislation of member states regarding electromagnetic compatibility , in abrogation of
Directive 89/336/CEE, per the following harmonised standards:
EN 61000-6-2:2005, EN 61000-6-3:2007.
• DIRECTIVE 2006/95/CE OF THE EUROPEAN PARLIAMENT AND COUNCIL, 12 December 2006, in relati-
on to the harmonisation of the legislation of member states regarding electrical material intended to be used within
certain voltage ranges, per the following harmonised standards:
EN 60335-1:2002 + A1:2004 + A11:2004 + A12:2006 + A2:2006 + A13:2008; EN 60335-1-103:2003.
as applicable:
• DIRECTIVE 1999/5/CE OF THE EUROPEAN PARLIAMENT AND COUNCIL, 9 March 1999 in relation to
radio equipment and telecommunications terminals and the mutual recognition of their conformity, per the following
harmonised standards:
ETSI EN 301 489-3 V1.4.1 (2002) + ETSI EN 301 489-1 V1.4.1 (2002) + ETSI EN 300 220-3 V1.1.1 (2000) + EN
60950-1 (2001)
Benincà Luigi, Legal representative.
Sandrigo, 02/11/2010.
4
DA.SO4 Control unit with microcontroller
channel of the receiver to the connector J3, short circuit J7-J8
st

CE Declaration of Conformity