Electrical Data - Ingersoll Rand ENL 10 Instruciones De Instalación Y De Servicio

EN
Supply voltage (see type plate)
Power consumption
Recommended cable-jacket diameter
Recommended wire cross section Spring-loaded
terminal (voltage supply/relay)
Recommended wire cross section
Screw terminal (voltage supply)
Recommended wire cross section Spring-loaded
terminal (external test)
Recommended wire cross section Screw terminal
(relay/external test)
Recommended stripping of cable jacket (voltage
supply/relay)
Recommended stripping of cable jacket (external
test)
Recommended length of the wire end tube Spring-
loaded terminal
Recommended length of the wire end tube Screw
terminal
Connection data of the potentialfree contact
Switch to load*
Connection data of the potential-free contact
Switch to low signal*)
Connection data of the external test contact
Protection class
Overvoltage category (IEC 61010-1)
VAC = V alternating current
VDC = V direct current
* The switching of loads means that the properties of the contact are no longer suitable for the switching of low signals.
6

6. ELECTRICAL DATA

9...240 VAC ±10% (0...60 Hz) /100...12 VDC ±10%
or
24...48 VAC ±10% (0...60 Hz) / 18...72 VDC ±10%
P = 0,6 ...  VA (W)
Ø ,0...10 mm (0,20"...0,9")
0,7...1, mm² (AWG 16...20)
0,7...2, mm² (AWG 14...20)
0,7...1,0 mm² (AWG 18...20)
0,7...1, mm² (AWG 16...20)
~ 0 mm (~ 1.18")
~ 90 mm (~ .4")
~ 8 mm (~ 0.1 inch)
~ 6 mm (~ 0.24 inch)
AC: max. 20V / 1A
DC: max. 0V / 1A
min.  VDC / 10 mA
on the unit side  VDC; switching current ≥ 0, mA
IP 67
II
ingersollrandproducts.com 80446222