Klarstein Windflower Manual Del Usuario página 15

Assembly instructions
The fan is packaged with its grills un-attached. You must attach the grills before
operating the fan.
Warning: Never operate the fan without its foundation and other parts.
The fan must only operate in the up-right position, and any other position
will be hazardous. Do operate the fan only in upright position; any other
position could create a hazardous situation
Assemble the foundation and other parts of the appliance in the following sequence:
Used as stand fan
1. Unpack the fan and remove all parts from the package
2. Insert the bottom tube(15) into the hole of base (16). Put the screw (17) under the
base and tighten the base with a L shaped hex key (18) clockwise.
3. Insert the top tube (13) into the middle of bottom tube(15), and align the bolt at the
screw holes and tighten the bolt (14)
4. Insert the fan head (10) into the middle of top tube and align the screw hole, screw
and tighten the bolt (1 1)
5. Use the fasten nut(4) for the back grill (5) to attach the back grill to the fan head
(6), and then use the fasten nut (2) for the fan leaf (3) to hold the fan leaf in place.
6. To attach the front grill to the back grill, you must use the grill ring carefully to hold
them together, and fasten the grill ring with the screw provided.
Used as desk fan
The step is same as above. Just remove the top tube (13), and screw the fan head to
bottom tube.
EN
15