Publicidad
Step 5
Insert the INTERLOCK TRACK (Z) with CABINET ACTUATORS (T) into the groove in
å
the RIGHT END (A2) exactly as shown.
Separate the EXTENSION SLIDES (N) from the EXTENSION RAILS (M) as shown in
å
the upper diagram. Be prepared, the parts are greasy.
Fasten two EXTENSION RAILS (M) to each END (A2 and B2). Use eight GOLD 5/16"
å
FLAT HEAD SCREWS (GG).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the
å
enlarged diagram. Then, slide the inner cartridge of the EXTENSION RAIL out to fi nd
the other hole that lines up with the hole in the END. Turn a SCREW into this hole.
N
Push the black lever in and pull the SLIDE from the RAIL.
Hole
Open end
Page 10
Z
M
B2
M
M
T
M
A2
M
After fastening the RAILS to the ENDS, rest
the INTERLOCK TRACK assembly against the
RAILS. There should be no more than a 1/16"
gap between all ACTUATORS and RAILS.
409044
GG
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
Open end
www.sauder.com/services
Publicidad
