Virutex FR129 VB Manual De Instrucciones página 2

ENGLISH FR129 VB Router for fitting hinges
ESPAÑOL Fresadora de herrajes FR129 VB
E N G L I S H
ROUTER FOR FITTING HINGES FR129 VB
Important note
Carefully read the GENERAL SAFETY INS-
TRUCTION LEAFLET enclosed with the machine
documents.
Keep both sets of instructions for any future
queries.
Important note
Carefully read the GENERAL SAFETY INS-
TRUCTION LEAFLET enclosed with the machine
documents.
1. Before plugging in the machine, make sure that the
power supply voltage is the same as that shown on the
specifications plate.
2. Always keep hands clear of the cutting area. Always
hold the machine safely.
3. Always use original VIRUTEX tools. Never use defective
or damaged tools.
4. Always use cutter bits with the appropriate stem diameter
for the chuck collet and tool speed to be used.
Unplug the machine from the mains before
carrying out any maintenance operations.
1. CHARACTERISTICS
Power...........................................................750 W
No load speed...........................................30,000/min
Weighted equivalent acoustic
pressure level...............................................85 dB A
Usual level of vibrations (hand-arm)....................<2.5m/s
2
OPERATING INSTRUCTIONS
MANUAL DE INSTRUCCIONES
Chuck diameter.................................................1/4" mm
Weight..............................................................4.3 kg
2. SPECIFICATIONS
Lengthways displacement of milling cutter shaft
5 " = 145 mm
11/16
Sideways displacement of milling cutter shaft
2 " = 54 mm
1/8
Lengthways milling with cutter bit Ø 1
6 " = 176 mm
15/16
Sideways milling with cutter bit Ø 1
3 " = 85 mm
3/8
Minimum opening between clamp vises
1 " = 33mm
5/16
Maximum opening between clamp vises
8" = 203 mm
Cutter bit maximum diameter
1" = 26 mm
Maximum milling depth
7/16" = 11mm
The following concepts are dealt with in the different
sections of this manual. Please see (Fig. 1).
A = Width of rebate
B = Width of hinge wing
R = Depth of rebate (Interior side of rebate)
Right opening door
Left opening door
The FR129 VB router enables you to make recesses for
rectangular hinges without using a template.
The corners of the recesses will have radius R (Fig. 15a) of
the TCT bit used. This means that if the original ½" TCT
bit is used, the radius will be ¼".
If you are planning to fit large hinges with a corner radius
of 5/8 ", use our optional 1
If you wish to fit hinges without a radius in the corners,
we have an optional accessory, "90º corner chisel 2945471"
2
¼ ":
¼ ":
" bit 2945499.
1/4
page/
página
2
6