Connect The Water Supply - PROFLO PF9002SWH Instrucciones De Instalación

InstallatIon InstructIons
skIrted het two pIece toIlet
Install Toilet Tank to Bowl
1. Carefully remove the tank from the packag-
ing and lay it on a clean and stable surface
on the tank back.
2. Check tank fittings and handles for tight-
ness, then install the rubber coupling
gasket onto the stem of the flush valve.
3. Connect the flexible supply tube to the fill
valve and snug the connection tight by
hand.
4. Insert the brass washer onto the tank con-
nection bolts first, then insert the rubber
gasket onto the tank connection bolts and
slide them to the base head of the bolt.
5. Now insert the connection bolt
assemblies into the tank to bowl
connection holes.
6. Gently lift the tank to the upright position
and place it on the bowl making sure to
align the flexible supply tube, flush valve
gasket and connection bolts with the
proper locations on the bowl. Now set in
place carefully holding the tank from
tipping and holding in a downward force.

Connect the Water Supply

1. Route the supply tube from behind the bowl
and connect to the Water Shut-Off Valve.
2. Open valve slowly and check for all leaks in
connections and toilet.
CAuTION: Over tightening of Lock Nut or
Coupling Nut could result in breakage and
possible flooding.
CAuTION: Do not use cone washer with
plastic supply line.
Flexible
Supply
Tube
7. Slide the brass washer first, then the con-
nection nuts onto the end of the connection
bolts located from around the back of the
bowl. Tighten the bolts evenly and in equal
pressure until a snug and water tight seal
is made.
Water
Shut-Off
Valve
WARNING: Do not use plumbers putty, pipe
dope or any other sealant on the water
supply connections to this tank.
Chain Hook to
be attached to
trip lever
Tank
Connection
Bolts (2)
Tank Flapper
Tank
Connection
Washer (2)
Tank
Connection
Gasket (2)
Rubber
Coupling
Gasket
Bottom Tank
NOTE: DO NOT OVERTIGHTEN!
DO NOT SPIN HEAD OF BRASS
BOLT WITH SCREWDRIVER!
DO NOT use sealants or silicon
on this fitting.
3. Use the thumb screw on the fill valve to
adjust water level to the waterline mark.
WaterLine
WARRANTY is void if any type of sealant is
used on the water supply connection.
Connection
Washer (2)
Nuts (2)