Connecting The Connecting Cable To The Weighing Platform - Seca 899 Manual De Instrucciones

Power supply
The scale is generally powered by batteries.
The LC display has a low power consumption – approx. 10.000 weighing operations can
be performed with one set of batteries.
bAtt
When or
require 6 AA-type 1.5 V batteries.
– Carefully turn over the scale so that the
base of the scale is accessible.
– Open the battery compartment lid and
insert the batteries supplied according
to the polarity shown on the battery
compartment.
Check that the polarity is correct!
– Close the cover.
– Then turn the scale back up the right
way.
Note: the scale is prepared for use
with a seca mains unit which is availa-
ble as an accessory.

Connecting the connecting cable to the weighing platform

The connecting cable of the display part is used to transmit digital data which are consid-
erably less sensitive to interference than the otherwise conventional small analog meas-
uring signals. Ageing and wear on the cable and on the plug contacts thus have no effect
on the accuracy of the scale.
To make the connection, proceed as outlined below:
– Connect the cable of the display case to
the socket under the carrying handle.
– Then place the scale upright again.
The cable may not contact the weighing
platform during weighing, as this might
falsify the result.
Model 899
appear in the display, you should change the batteries. You
Connection for mains unit
GB
21