Changing The Batteries - Seca 899 Manual De Instrucciones

St0p
... appears in the display?
– Maximum load has been exceeded.
... the display flashes?
– If you have just activated the Hold or Tare function, please wait until the scale has de-
tected a steady weight value. The display will then stop flashing.
– If there has been no activation of a function beforehand, remove the load from the scale
0. 0
and wait until
E
... the display and a number appear?
– Switch off the scale with the Start key and start the scale again. The scale will then
work normally again.
If this is not the case, disconnect the power supply by briefly removing the batteries. If
this measure is equally unsuccessful, inform the Service department.
7. Servicing/verification
Have the scale verified by authorised persons in accordance with national legal require-
ments. Verification is essential if one or more security marks are damaged.
We recommend having your scale serviced by your local service agent before having it
verified. seca Customer Service will be pleased to give you further assistance.

Changing the batteries

bAtt
When or
6 type AA 1.5 V batteries.
– Carefully turn over the scale so that the
base of the scale is accessible.
– Push the battery compartment closure
towards "Battery" and open the cover.
– Remove the used batteries and insert
new batteries.
Check that the polarity is correct.
– Close the cover.
– Then turn the scale back up the right
way.
Model 899
is displayed, then weigh again.
appear in the display, you should change the batteries. You need
GB
27