For Your Safety; Machine Elements; Intended Use; Noise/Vibration Information - Würth Master BM 10-XE Instrucciones Para El Manejo

BM 10-XE - Buch Seite 7 Mittwoch, 6. Dezember 2006 10:07 10
GB
Working safely with this machine is pos-
sible only when the operating and safety
information are read completely and the
instructions contained therein are strictly
followed. In addition, the general safety
notes in the enclosed booklet must be observed.
Before using for the first time, ask for a practical
demonstration.
The unit must not be damp and must not
be used in a wet environment.
Wear hearing protection. Exposure to
noise can cause hearing loss.
Before each use of the machine, check
the machine, cable and plug. Have
repairs carried out only through the
Würth Master-Service or by a qualified
technician. Insert the plug into the socket
only when the machine is switched off.
When working with the machine, always hold it
firmly with both hands and provide for a secure
stance. The power tool is guided more secure with
both hands.
Secure the workpiece. A workpiece clamped with
clamping devices or in a vice is held more securely
than by hand.

Machine Elements

The numbering of the machine elements refers to the
illustration of the machine on the graphics page.
1 Keyless chuck
2 Auxiliary handle collar
3 Ventilation slots
4 Rotational direction switch
5 Lock-on button
6 On/Off switch
7 Latch for mains cable module
8 Securing screw
9 Allen key
Not all of the accessories illustrated or described are included
as standard delivery.

For Your Safety

Do not work materials containing asbestos.
Asbestos is considered carcinogenic.
Always wait until the machine has come to a
complete stop before placing it down. The tool
insert can jam and lead to loss of control over the
power tool.
Hold the machine with a firm grip. High reaction
torque can briefly occur while driving in and loos-
ening screws.
Do not use a machine with a damaged mains
cable. Do not touch the damaged cable and pull
the mains plug when the cable is damaged while
working. Damaged cables increase the risk of an
electric shock.
Connect machines that are used in the open via a
residual current device (RCD).
Use suitable detectors to determine if utility lines
are hidden in the work area or call the local util-
ity company for assistance.
Contact with electric lines can lead to fire and elec-
tric shock. Damaging a gas line can lead to explo-
sion. Penetrating a water line causes property
damage or may cause an electric shock.
Hold the machine only by the insulated gripping
surfaces, when performing an operation where
the cutting tool may run into hidden wiring. Con-
tact with a "live" wire will make exposed metal
parts of the tool "live" and shock the operator.
Use only original Würth parts and accessories.
For further notes on safety refer to the enclosed sheet
The drill can be used for drilling in wood, metal and
plastics and for screwdriving.
The user is responsible for damage caused by usage
other then intended.

Noise/Vibration Information

Measured
EN 60 745-1.
Typically the A-weighted sound pressure level of the
product is 79 dB (A). The noise level when working can
exceed 90 dB(A). Measurement uncertainty K=3 dB.
Wear hearing protection!
The typical hand-arm vibration is below 2.5 m/s

Intended Use

values determined according to
2 .
7