For Your Safety; Safety Warnings For Drills - Würth EDSB 160-E Traducción Del Manual De Instrucciones De Servicio Original

OBJ_BUCH-0000000384-001.book Page 19 Thursday, May 9, 2019 3:08 PM
Read all safety warnings and
all instructions. Failure to follow
the warnings and instructions may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-oper-
ated (cordless) power tool.
 Wear hearing protection when drilling
with impact. Exposure to noise can cause hear-
ing loss.
 Use auxiliary handles if supplied with the
power tool. Loss of control can lead to injury.
 Hold power tool by the insulated grip-
ping surfaces, when performing an oper-
ation where the cutting accessory may
contact hidden wiring or its own cord. Cut-
ting accessory contacting a "live" wire may make
exposed metal parts of the power tool "live" and
could give the operator an electric shock.
 The built-in safety clutch only responds to sudden
jerky blocking; therefore, always use the auxiliary
handle.
 Use protective equipment. When working with the
power tool, always wear safety glasses/goggles.
Protective clothing, such as dust protection mask,
protective gloves, sturdy and non-slip footwear,
hard hat and hearing protection are recommended.
 Do not work materials containing asbes-
tos. Asbestos is considered carcinogenic.
 Switch off the power tool immediately if the applica-
tion tool is blocked or jams! Do not switch the
power tool on again while the application tool is
blocked; this could lead to kickback with high reac-
tion torque. Determine and correct the cause of the
blockage of the application tool, taking the safety
warnings into account.

For Your Safety

Safety Warnings for Drills

Possible causes could be:
• Jamming in the workpiece
• Breaking through the material being worked
• Overloading the power tool
 Do not reach into the running power tool.
 The application tool can become hot during opera-
tion.
WARNING! Danger of burning when changing
application tools or placing down the power tool.
 Chips or splinters may not be removed while the
power tool is running.
 Always keep the connection cable away from the
working area of the power tool. Always conduct
the mains cable to the rear away from the power
tool.
 When drilling in walls, ceilings or floors, pay atten-
tion to electrical cables, gas and water lines.
 Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
 For large drill diameters, the auxiliary handle must
be attached at a right angle to the main handle
(also see figure in section "rotate handle").
 Use only original Würth accessories.
Working safely with this product
is possible only when the operat-
ing and safety information are
read completely and the instruc-
tions contained therein are strictly
followed.
19