Environmental Protection; Technical Data - Metabo PowerMaxx CC 12 BL Manual Original

en ENGLISH
11. Accessories
Use only original Metabo or CAS (Cordless Alliance
System) battery packs and accessories.
Use only accessories that fulfil the requirements
and specifications listed in these operating
instructions.
Chargers: ASC 55, SC 30, etc.
Battery packs with different capacities. Buy
battery packs only with voltage suitable for your
power tool.
12 V, 2.0 Ah, Li-Power......................... 625406000
12 V, 4.0 Ah, LiHD ............................... 625349000
18 V, 2.0 Ah, Li-Power......................... 625596000
18 V, 4.0 Ah, LiHD ............................... 625367000
etc.
For a complete range of accessories, see
www.metabo.com or the accessories catalogue.
12. Repairs
Repairs to electrical tools must ONLY be
carried out by qualified electricians!
Contact your local Metabo representative if you
have Metabo power tools requiring repairs. For
addresses see www.metabo.com.
You can download a list of spare parts from
www.metabo.com.

13. Environmental Protection

The sanding dust generated may contain
hazardous materials: do not dispose of dust with
household waste, but at a special collection point
for hazardous waste.
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Battery packs must not be disposed of with regular
waste! Please return faulty or used battery packs to
your Metabo dealer!
Do not throw battery packs into water.
Only for EU countries: never dispose of
power tools in your household waste!
According to European Directive 2012/19/EU
on Waste from Electric and Electronic Equipment
and implementation in national law, used power
tools must be collected separately and recycled in
an environmentally-friendly manner.
Discharge the battery pack in the power tool before
disposal. Prevent the contacts from short-circuiting
(e.g. by protecting them with adhesive tape).

14. Technical Data

Explanatory notes on the specifications on page 2.
Changes due to technological progress reserved.
U = voltage
(max. voltage = 12 V,
nominal voltage = 10.8 V)
D = max. diameter of accessory
16
max
d = drill diameter of the accessory
t = max. permitted thickness of the
max,1
clamping shank on accessory
when using a two-hole nut (1)
t = roughing disc/cutting disc:
max,3
max. permitted thickness of
accessory
M = Spindle thread
n = No-load speed (maximum speed)
P = Rated input power
1
P = Power output
2
m = Weight (with smallest battery pack)
Measured values determined in conformity with
EN 60745.
direct current
The technical specifications quoted are subject to
tolerances (in compliance with relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. The actual load may be higher
or lower depending on operating conditions, the
condition of the power tool or the accessories used.
Please allow for breaks and periods when the load
is lower for assessment purposes. Arrange
protective measures for the user, such as
organisational measures based on the adjusted
estimates.
Total vibration value (vector sum of three
directions):
a = Vibration emission value (surface
h, SG
grinding)
a = Vibration emission value (cut-off
h, TS
grinding)
K = Uncertainty (vibration)
h,SG/TS
Typical A-effective perceived sound levels:
L = Sound-pressure level
pa
L = Acoustic power level
WA
K , K = Uncertainty
pA WA
During operation the noise level can exceed
80 dB(A).
Wear ear protectors!