Kohler Elate 707618-8G79-BL Manual De Instrucciones página 14

10. Install the Threshold Seal
Indent
CAUTION: Risk of product damage. A notch is required on the bumper for the fixed panel side only. An indent on
the inside top of the bumper indicates where the notch should be cut. Do not cut a notch in the bumper for the
sliding panel side.
NOTE: The fixed panel should be installed on the opposite side of the showerhead.
Remove the fixed panel side bumper.
Cut a notch in the fixed panel side bumper along the indent on the inside top of the bumper.
Reinstall the fixed panel side bumper.
Measure the bottom length of the fixed panel and subtract 5/8" (16 mm).
Mark the measurement on the threshold seal and cut to length.
Slide the threshold seal into the channel of the threshold and align the seal with the front of the bumper.
Press the remainder of the threshold seal into the groove on the threshold.
1460483-2-B
Notch
14 Kohler Co.