KTM Power Parts 61408916544 Manual Del Usuario página 10

10
Preassembly
- Position tail light on base support
- Mount screws (included) and tighten.
- Mount rubber grommet (included).
- Position license plate lighting
(both included) or USA license plate holder
- Position the bracket for refl ector
EU license plate holder .
- Mount refl ector (included) on the bracket for refl ector
NOTE
The further steps are the same on both license plate holders. The
example shown is the EU license plate holder
- Position the original turn signal.
- Mount and tighten nuts with the washers.
NOTE
Right turn signal = green adhesive tape on the cable
Left turn signal = red adhesive tape on the cable
Optional
- Position the LED turn signal.
- Mount and tighten nuts with the washers (included with LED
turn signal).
- Mount protection caps (included with LED turn signal).
- Plug in resistances (included with LED turn signal).
(both included).
on EU license plate holder
.
with screws (all included) on
.
.