KTM Power Parts 61408916544 Manual Del Usuario página 11

NOTE
The further steps are the same for both turn signals. The example
shown are the original turn signals.
- Position the cable for right turn signal
as shown on base support
- Position cable for license plate lighting
- Secure the cable with cable ties.
- Thread adapter wiring harness
Route all cables free of tension and ensure that the cables can-
not be kinked or pinched!
- Plug in the socket connector for right turn signal
signal into adapter wiring harness
NOTE
Right turn signal = plug into black and brown
Left turn signal = plug into purple and brown
- Plug in the socket connector for license plate lighting
wiring harness .
NOTE
License plate lighting = plug into yellow and brown
- Plug in the socket connector for tail light
harness .
- Position left cover plate
- Mount screws (included) and tighten.
Ensure that the cables can neither become kinked or pinched!
- Position the license plate holder support on the license plate holder.
- Mount cross connector (included).
- Mount screws (included) and tighten.
- Position top cover plate
- Position rubber grommet
and for left turn signal
.
as shown.
through rubber grommet
and for left turn
.
into adapter wiring
and right cover plate (both included).
(included).
over the cover plate.
.
into adapter
11