Sauder 411606 Manual De Instrucciones página 12

Step 8
Bend the fl ap up on the BACK (I) and then lay it over the
å
opening between the RIGHT END (A3) and UPRIGHT (C3).
Fasten the BACK (I) to your unit using the NAILS (1N).
å
NOTE: The BACK should be touching the bottom surface
å
of the TOP (E2). Do not nail into the RIGHT END (A3).
Fasten the fl ap of the BACK (I) to the RIGHT END (A3).
å
Use six BLACK 9/16" LARGE HEAD SCREWS (1S).
NOTE: Perforations have been provided for access through
å
the BACK. Carefully cut out the holes needed.
BLACK 9/16" LARGE HEAD SCREW
(6 used in this step)
Flap
Page 12
1S
A3
I
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
E2
C3
This perforation
should be here.
411606
Caution
1N
NAIL
(10 used in this step)
B3
www.sauder.com/service