Publicidad
Step 13
To make adjustments to the drawer, loosen SCREW #3 in the SLIDES a 1/4 turn, then turn the CAM
å
clockwise or counter-clockwise. Notice how the drawer raises or lowers as you turn the CAM. The
higher the screw in the oblong hole, the higher your drawer front will be. The lower the screw, the
lower the drawer front. By adjusting the drawer this way, it will help the DRAWER FRONT line up
better when closed. Tighten the SCREWS when fi nished with adjustments.
NOTE: Please read the back pages of the instruction booklet for important safety information.
å
This completes assembly. Clean with your favorite furniture polish or a damp cloth. Wipe dry.
å
And to celebrate, why not share your success story at Walmart.com or
The higher the screw in the oblong hole,
the higher your drawer front will be. The
lower the screw, the lower the drawer front.
www.sauder.com/service
Loosen screw #3 a 1/4 turn, turn the cam a 1/4 turn
maximum in both the clockwise and counter-clockwise
directions to make adjustments, and then tighten screw #3.
Cam
411606
Page 17
Publicidad
