Publicidad
Step 9
1
D20
K2
Groove
Insert the DRAWER SIDES (D20 and D21) at an angle
å
into the slot at each end of the DRAWER FRONT (K2).
3
Fasten the DRAWER BACK (D148) to the DRAWER
å
SIDES (D20 and D21). Use four BLACK 1-9/16" FLAT
HEAD SCREWS (30S).
NOTE: Be sure the DRAWER BOTTOM (D951) inserts into
å
the groove of the DRAWER BACK (D148).
www.sauder.com/service
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D21
D148
D951
D20
D21
VIEW THE T-LOCK BOX VIDEO
2
U n fi
s u r
D20
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D951) into the grooves in the
å
DRAWER SIDES (D20 and D21) and DRAWER FRONT (K2).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
(4 used in this step)
411606
With the palm of your
hand, tap the DRAWER
BOTTOM down into
the groove.
n i s h
e d
f a c
e
D951
D21
K2
30S
Page 13
Publicidad
