Warn VR10000 Manual De Instrucciones página 4

Mounting location:
(1) Smooth and flat, thickness = 1/4" (6.4 mm)
(2) 3/8" (9.525 mm) lockwasher X 4
(3) 3/8-16 X 1 1/4" long, grade 5 bolt X 4
torque 30-35 ft. lbs. (41-47Nm)
Mounting bolt pattern:
10" x 4.5", 254mm x 114.3mm (standard)
6" x 4.5", 152mm x 114.3mm (short drum)
2
3
Solenoid Pack Installation
• Mount the control pack according to the
instructions included in the WARN mounting
system kit. Use the bracket included in the kit.
• To mount the control pack directly to the winch,
order control pack bracket part number 26368.
• The control pack mounting fasteners may also
be moved to the unused holes in the control pack
base plate for additional mounting flexibility.
RED CABLE 72" (183 cm)
BATTERY
WINCH MOUNTING
3/8 " (9.5 mm) X 4
STANDARD
HOLE PATTERN
10 " (254 mm)
3/8 " (9.5 mm) X 4
SHORT DRUM
HOLE PATTERN
1
6 " (152 mm)
ELECTRICAL CONNECTIONS
F1
A
MOTOR GROUND WIRE
BLACK CABLE 72" (183 cm)
5
OPERATING INSTRUCTIONS
CAU TI ON
ALWAYS KNOW YOUR WINCH: Take
4 1/2 "
time to fully read and understand the
(114 mm)
included Installation and Operations
Guide, and Basic Guide to Winching
Techniques, in order to understand
your winch and the winching operation.
REMOTE CONTROL SWITCH
Do not leave the remote plugged into the winch
4 1/2 "
when not in use. Leaving the remote plugged in,
(114 mm)
may result in a dangerous condition and/or battery
drain.
LINE
IN
1
DOWN
3
2
REMOTE
CONTROL
SWITCH
LINE
OUT
UP
REMOTE
CONTROL
F2
SWITCH
LINE
OUT
CLUTCH OPERATION
When the clutch is engaged the gear train is
coupled to the wire rope drum and power may be
transferred from the winch motor. When the
clutch is in free spool the gear train and wire rope
drum are uncoupled allowing the drum to rotate
freely. The clutch knob, located on the winch
housing
opposite the motor, controls the clutch position.
To prevent damage, always fully engage or fully
disengage the clutch knob.
CAU TI ON
To avoid minor or moderate injury:
• Never engage or disengage clutch if
winch is under load, wire rope is in
tension or wire rope drum is moving.
DISENGAGED
ENGAGED
LINE
IN
6