Sauder 411660 Manual De Instrucciones página 11

Step 7
Carefully turn your unit onto its front edges. Lay the BACKS (H4)
å
over your unit.
Make equal margins along the bottom and both side edges of the
å
BACKS (H4). Push on opposite corners of your unit if needed to
make it "square".
Fasten the BACKS (H4) to your unit using the NAILS (1N).
å
With a hammer, tap four TACK GLIDES (13E) into the edges of the
å
ENDS (A2 and B2) and END MOLDINGS (L2).
13E
A2
L2
13E
www.sauder.com/service
Edge of BACK with no holes.
H4
411660
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
(26 used in this step)
Edge of BACK with no holes.
H4
B2
L2
1N
NAIL
13E
Page 11