Quick Installation - Tripp-Lite SmartPro Manual De Operación

Quick Installation

1 Plug your UPS into a 3-wire
grounded, 120V AC, 60 Hz
utility outlet.
You must plug a hospital-grade UPS system
into a hospital-grade outlet to achieve ground-
ing reliability. UL2601-1 listed UPS systems
only meet UL standard 2601-1 for medical
equipment when plugged into a hospital-
grade outlet.
Your UPS will run a self-test after it is
plugged in. See Basic Operation to understand
the results of its self-test.
Plug your equipment into
2
your UPS.
You will overload your UPS if you connect
high power draw equipment such as large
motor-driven devices, laser printers or surge
suppressors to its outlets.
3 Select UPS Operating
Mode.*
Press the UPS/STANDBY button to toggle
your UPS between the UPS ("
and the STANDBY ("
modes. Choose the operating mode based on
your location:
USA, Canada & Western Europe:
• Leave the UPS in the UPS mode at all
times.
All Other Countries:
• Put the UPS in the STANDBY mode when
you are not using connected equipment.
(WARNING! When set to "CHARGE ONLY," the UPS
will not provide battery backup during a blackout or
brownout)
• Put the UPS in the UPS mode when you
are using connected equipment.
*See Basic Operation section for a complete explanation
of each mode.
" LED lit)
" LED flashing)
4
1
2
3