Publicidad
Idiomas disponibles
Idiomas disponibles
- Do not move the appliance whilst in operation or if the oil is still hot. Once
cooled, transport the appliance using the handles.
- Use the appliance handle/s, to catch it or move it.
- Do not fry food under the appliance, without attending to it.
- Respect the MAX and MIN levels. (Fig.1)
- Disconnect the appliance from the mains when not in use and before underta-
king any cleaning task.
- This appliance should be stored out of reach of children and/or the disabled.
- Do not store or transport the appliance if it is still hot.
- Never leave the appliance unattended while in use.
- Never leave the appliance unattended when in use and keep out of the reach
of children, as this is an electrical appliance that heats oil to high temperatures
and may cause serious burns.
- Use only utensils appropriate to support high temperatures.
- If fat is used instead of oil, melt first in a separate recipient (Fig.2)
- If fat has hardened in the pan, make a few holes in the solid fat in order to
allow the water, which has been retained in the fat to be released as steam
when heated at the minimum thermostat temperature (Fig.3)
- If, for some reason, the oil were to catch fire, disconnect the appliance from
the mains and smother the fire using the lid, a cover or a large kitchen cloth.
NEVER WITH WATER.
- Turn the thermostat control to the minimum (MIN) setting. This does not mean
that the appliance is switched off permanently.
- Any misuse or failure to follow the instructions for use renders the guarantee
and the manufacturer's liability null and void.
Instructions for use
Before use:
- Make sure that all the product's packaging has been removed.
- Before using the product for the first time, clean the parts that will come into
contact with food in the manner described in the cleaning section.
Oil filling:
- Open the cover
- Ensure that the electrical equipment is appropriately positioned.
- Pour oil up to the mark indicating the MAXIMUM level on the bowl (Fig.4).
- The appliance must not be used with less oil than that indicated by the
MINIMAL mark.
Use:
- Unroll the cable completely before plugging it in.
-Take off the lid.
-This fryer is not designed to fry with the lid on.
-Remove the basket and attach the handle by inserting it until the rods engage
in the housing.
- Connect the appliance to the mains.
-Turn the appliance on by turning the select knob
-The connection pilot light will come on.
- Select the desired frying temperature using the thermostat control. The indica-
tor light will turn on indicating that the oil is being heated.
- Prepare the food to be fried and place it in the basket, making sure that it
does not rise above ¾ of its capacity. Allow the food to drain before placing it
in the basket.
- Frozen food must be allowed for thaw beforehand. The placing of frozen food
or food with high water content in the basket may cause the oil to suddenly spit
after a few seconds.
- Wait until the blue pilot light has gone out which will indicate that the applian-
ce has reached an adequate temperature.
- During the appliance's use the blue pilot light will come on and off automati-
cally, indicating the heating elements are working, and therefore maintaining the
desired temperature.
- Slowly place the basket in the bowl to avoid overflowing and splashing.
-During the frying, never put the lid on the appliance. The lid has to put only for
the spin function.
- When the food has been fried sufficiently, lift the basket and position it in the
support in order to allow the excess oil to drain from the food.
- Empty the basket.
- Change the oil approximately every 15 or 20 frying operations, or every 5 – 6
months if not used frequently.
- In order to minimize the generation of acrilamida during the frying process,
avoid to reach dark brown colours on the fried food, remove any burnt leftovers
from the oil container, food rich in starch (such as potatoes or corns) should not
be fried at temperatures higher to 170ºC.
Spin function:
- This fryer has spin function to remove the oil excess from the food.
-That function has be done once the food has been fried to.
- Disconnect the appliance from the mains.
-In order to start the spin function, you will have to follow the below step:
1) When frying is done, raise the basket to its limits.
2) Put the lid on the appliance.
3) Turn the ratchet spin button which is on the lid from the left to the right
4) the basket will begin to spin.
WARNING: do not remove the lid while the basket is turning.
And, depending on whether it spatters upwards, something like this could
even also be included:
Carefully remove the lid to prevent accidental contact with possible left-over hot
oil which may remain at its top part.
Manual Professional Spin.indb 11
Once you have finished using the appliance:
- Select the minimum position (MIN) using the thermostat control.
- Unplug the appliance from the mains.
- Put the cable back in the cable housing.
-Place the basket in the bowl.
-The basket handle can be left fixed or folded towards the basket by pressing
the bar to the side and turning it.
-Put the lid on the appliance.
Cable compartment
- This appliance has a cable compartment situated on its underside.
Carry handles:
- This appliance has a handle on the side of the body, which facilitates comfor-
table transport .
Practical recommendations:
- Fry a few pieces of bread to remove the smell of used oil.
- For food with a high water content, it is better and quicker to fry in two lots with
less food than in just one. This will reduce the risk of splashes and spillage.
- The "two-stage frying method" can be used for an even and crispy coating.
This system consists of first frying the food until it is reasonably well done and
then frying again using very hot oil to brown the food.
- Olive oil with a minimum acidity level is recommendable for frying.
- Do not mix different oils.
- Wash potatoes before frying to stop them from sticking
Safety thermal protector:
- The appliance has a safety device, which protects the appliance from overheating.
- In the event of overheating, the thermal safety mechanism will be activated
and the appliance will stop operating. When this occurs the appliance should be
disconnected from the mains and left to cool. Then press the rearming button,
situated at the back of the electrical circuit, with the tip of a pen or similar in
order to reactivate the appliance (Fig.5).
Cleaning
- Disconnect the appliance from the mains and allow it to cool before underta-
king any cleaning task.
- Disassemble the appliance in accordance with the following steps:
Remove the lid. Remove the basket and take out the electrical equipment.
Remove the bowl.
Carefully pour the used oil from the bowl into a container (not the sink), accor-
ding to the regulations in force for the treatment and disposal of waste.
Turn the body of the fryer and dismount the connection from the mains pressing
on the clip and pulling outwards. Unplug the mains cable from the its housing
and separate from the fryer.
- Except for the power unit and the mains connection, all the parts can be
cleaned with detergent and water or in washing up liquid. Rinse thoroughly to
remove all traces of detergent.
- Clean the electrical equipment and the mains connection with a damp cloth
and dry. DO NOT IMMERSE IN WATER OR ANY OTHER LIQUID.
- Clean the equipment with a damp cloth with a few drops of washing-up liquid
and then dry.
- Do not use solvents, or products with an acid or base pH such as bleach, or
abrasive products, for cleaning the appliance.
- It is advisable to clean the appliance regularly and remove any food remains.
- The following pieces may be washed in a dishwasher (using a soft cleaning
program):
- Basket
-Tank
- The draining/drying position of the articles washable in the dishwasher or in
the sink must allow the water to drain away easily .
- Then dry all parts before its assembly and storage.
Anomalies and repair
- Take the appliance to an authorised technical support service if product is
damaged or other problems arise. Do not attempt to disassemble or repair the
appliance yourself as this may be dangerous.
For EU product versions and/or in case that it is requested in your country:
Ecology and recyclability of the product
- The materials of which the packaging of this appliance consists are included in
a collection, classification and recycling system. Should you wish to dispose of
them, use the appropriate public recycling bins for each type of material.
- The product does not contain concentrations of substances that could be
considered harmful to the environment.
This symbol means that in case you wish to dispose of the product
once its working life has ended, take it to an authorised waste agent
for the selective collection of Waste from Electric and Electronic
Equipment (WEEE).
This appliance complies with Directive 2006/95/EC on Low Voltage, Directive
2004/108/EC on Electromagnetic Compatibility, Directive 2011/65/EC on the
restrictions of the use of certain hazardous substances in electrical and electro-
nic equipment and Directive 2009/125/EC on the ecodesign requirements for
energy-related products.
28/05/14 15:15
Publicidad
