Chapin 81008A Manual De Instrucciones página 2

Auger is designed to work in forward motion. Excessive reverse motion could cause binding. If
resistance is felt while pulling spreader backwards, stop and clear salt from auger.
ASSEMBLY INSTRUCTIONS
Approximate assembly time is 5-10 minutes
Suggested Tools:
Wrench and/or Ratchet Set
• Remove bottom bolt from each side of
handle (below triangle shaped thumb screws)
• Loosen M6 Hex nuts and flip up handle
• Tighten M6 Hex nuts completely
Bolts
Handle
* Note: If spring detaches from bail assembly,
simply re-attach (see Figure A).
CHAPIN INTERNATIONAL, INC. P.O. BOX 549 700 ELLICOTT ST. BATAVIA, NY 14021-0549 www.chapinmfg.com 800-950-4458
WARNING
M6 Hex
Nuts
Figure A
Fully Assembled
Note: Model 81000A Does
not include baffle system.