General Safety Instructions - ABB EOHU Serie Boletín De Instrucciones

General safety instructions

Read these safety instructions carefully before using this product!
1
1/2 General safety instructions | Instruction Bulletin EOHU361K, EOHU362K, EOHU363K, 1SCC340035M1402 / B
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
– Apply appropriate personal protective equipment (PPE) and
follow safe electrical work practices. See NFPA 70E or CSA
Z462.
– This equipment must only be installed and serviced by
qualified electrical personnel.
– Before performing visual inspections, tests, or maintenance
on the equipment, disconnect all sources of electric power.
Assume that all circuits are live unless they are completely
deenergized, tested, grounded, and tagged. Pay particular
attention to the design of the power system. Consider all
sources of power, including the possibility of backfeeding.
– Never operate energized switch with door open.
– Turn off switch before making load side connections.
– Always use a properly rated voltage sensing device at all line
to confirm switch is off.
– Turn off power supplying switch before doing any other work
on or inside switch.
Failure to follow these instructions will result in death or
serious injury.