Snapper 7800982-00 Instrucciones De Instalación página 3

9. Using the fifth cable tie (N), secure the engine speed control
cable to the oil fill tube on the right rear of the engine.
10. Slowly pull the recoil handle out from the engine.
11. Hook the recoil rope into the rope guide.
WARNING
!
Keep hands and feet away from mower discharge. Failure to do
so may result in personal injury or death.
12. Install the control console (D) to the handle as shown with the
four self-tapping torx screws (O), using a T-30 torx bit. Tighten
securely.
NOTE: Route the drive cable (if equipped) through the relief
slot in the console. See inset.
N
!
11
9
10
O
12
en
D
3