Mains Supply; Control Panel - Bontempi 15 4912 Libro De Instrucciones

E N G L I S H

MAINS SUPPLY

The instrument can be supplied by the AC/DC (Vdc =5V / I
= 500 mA)
plied) conforms to national and international safety regula-
tions covering
electrical appli-
ances. Insert
EARPHONE MIC
the jack in the
DC 5V socket.
•The toy is not intended for children
under 3 years old •The toy must only be used with the recom-
mended adaptor •The toy is to be disconnected from the adaptor
before cleaning •The mains adaptor is NOT a toy.
RECOMMENDATIONS: The socket (1) for the adapter plug must be
easily accessible. • Inserting the plug into the socket at the back of
the instrument automatically cuts off supply from the batteries. •
Ensure that the adapter is sufficiently ventilated and that the venti-
lation slits are not covered with objects such as newpapers, table-
cloths, curtains, etc. • Do not expose the adapter to drops or
splashes of water. • The AC/DC adaptor shall not be exposed to
dripping or splashing and that no objects filled with liquids, such as
vases, shall be placed on apparatus. • The AC/DC adaptor is used as
disconnect device. • The AC/DC adaptor of apparatus should not be
obstructed OR should be easily accessed during intended used. • To
be completely disconnect the power input, the AC/DC adaptor of
apparatus shall be disconnected from the mains. • Battery shall not
be exposed to excessive heat such as sunshine, fire or the like. •
minimum distances 15cm around the apparatus for sufficient venti-
lations. • The ventilation should not be impeded by covering the
ventilation openings with items such as newspaper, table-cloths,
curtains etc. • No naked flame sources such as lighted candles
should be placed on the apparatus. • Attention should be drawn to
the environmental aspects of battery disposal. • The apparatus
should only be used in moderate climates.
WARNING: All batteries or transformers with safety insulation must
be checked regularly for faults in cable, wire, or plug insulation or
other parts.
NOTE: Rating plate information was located at bottom enclosure
of the apparatus.
BATTERY SUPPLY
Use a screwdriver to open the battery compartment. Insert
4 x 1.5 V batteries R6/AA (not supplied), ensuring correct
polarity. Re-fit battery cover.

CONTROL PANEL

1. ON /OFF button.
2. TEMPO –: Slows down the tempo of the rhythm or
song.
3. TEMPO +: Speeds up the tempo of the rhythm or
song.
4. START/STOP: Starts or stops the rhythms and demo
songs.
5. VOLUME +: Turns up the volume of music and
rhythms.
6. VOLUME –: Turns down the volume of music and
rhythms.
7. SELECT 0-9, +/–: Selection of sounds, rhythms:
Compose the number corresponding to the Sound or
Rhythm viewed on the list. Press + or – to go to the
next or previous one.
4
positive central adapter (sup-
DC5V
Replace batteries when the
quality of sound becomes bad.
Use alkaline batteries to obtain
a longer duration.
ADVICE ON
BATTERIES • Non-rechargeable bat-
teries are NOT to be recharged • Rechargeable batteries must be
removed from the product before being charged • Rechargeable
batteries are only to be charged under adult supervision • Different
types of batteries or new and old batteries are not to be mixed •
1
Use only batteries of the same or equivalent type • Batteries are to
be inserted with correct polarity • Remove exhausted batteries to
prevent leakage • Do not short circuit supply terminals • Remove
batteries during long periods of non-use.
WASTE DISPOSAL STANDARDS
For information regarding the disposal of the items mentioned here
below, please refer to Council Administration office regarding spe-
cialised waste collection centres.
1. DISPOSAL OF BATTERIES
Protect the environment by disposing of batteries
in the special containers provided for this use.
2. PACKAGING DISPOSAL
Take the paper, cardboard and corrugated board
to the appropriate waste collection centres. Plastic material must be
placed in the relevant collection containers.
The symbols indicating the various types of plastic are:
01
PET
Key for the different types of plastic materials:
PET= Polyethylene terephtalate • PE= Polyethylene, code 02 for
PE-HD, 04 for PE-LD • PVC =Polyvinyl chloride • PP= Polypropylene •
PS= Polystyrene, Polystyrene foam • O= Other polymers (ABS,
Laminates, etc.)
3. DISPOSING OF ELECTRICAL APPLIANCES
The wheelie bin symbol with a cross indicates that the
product must not be disposed of in the domestic waste at
the end of its useful life. Instead, it should be taken to your
nearest designated collection point or recycling facility.
Alternatively, check with your retailer and return the
product when buying a replacement, on a one-to-one basis or as
free of charge in case the size is smaller than 25cm. Appropriate
disposal promotes the recycling of parts and materials, as well as
helping to protect the environment and human health. Under cur-
rent legislation, strict penalties are enforced against those dispos-
ing of products illegally. For more information about the collection
of special waste, contact your Local Authority.
8. The LCD Display views information such as the entered
number and the tempo.
9. 4 rhythmic percussion instruments.
10. CHORD OFF: disables accompaniment (full-keyboard).
11. SINGLE: Enables accompaniment with the simplified
chord function: it allows you to compose chords on
the left part of the keyboard according to the Single
Finger Chord method (see Chords Table).
12. FINGER: Enables accompaniment in the classical mode:
all the main chords are recognised (see Chords Table).
13. FILL IN: The function inserts a rhythm variation.
Pressing this button while the rhythm is playing
produces a rhythmic variation of the drum.
14. SYNC: The SYNC function allows you to start the
rhythm and the accompaniment as soon as the chord
is composed in either Single or Finger mode.
USING THE
02 03 05 06
PE PVC PP PS
07
O