Programming; Disposing; Warranty - marklin 76480 Manual De Instrucciones

Programming

fx (MM) / mfx** / DCC
Programming of the CVs is done via the home signal. The
settings are taken directly from the home signal at CV 40 (see
instructions for the home signal).
CV Meaning
52 Switching duration
LED on/off
PoM*
Cross fading
54
behavior
PoM*
*PoM programming can be done on the main track as long as it is sup-
ported by the control device.
** mfx not until CS2 Software Version 4.0 (2nd quarter of 2015)
Values
0 - 3 0 = 0 seconds
1 = 0.175 seconds
2 = 0.35 seconds
3 = 0.5 seconds
0 - 3 0 = simultaneously
1 = one after the other
2 = one after the other
0.1 sec. pause
3 = one after the other
0.5 sec. pause

Disposing

Products marked with a trash container with a line
through it may not be disposed of at the end of
their useful life in the normal household trash. They
must be taken to a collection point for the
recycling of electrical and electronic devices.
There is a symbol on the product, the operating
instructions, or the packaging to this effect. The
materials in these items can be used again according to this
marking. By reusing old devices, materially recycling, or
recycling in some other form of old devices such as these you
make an important contribution to the protection of our
environment. Please ask your city, town, community, or county
authorities for the location of the appropriate disposal site.

Warranty

The warranty card included with this product specifies the
warranty conditions.
• Please contact your authorized Märklin dealer for repairs or
contact:
Gebr. Märklin & Cie. GmbH
Reparaturservice
Stuttgarter Str. 55 - 57
73033 Göppingen
Germany
 : +49 7161 608 222
E-Mail: Service@maerklin.de
9