Sauder Parklane 423106 Guia De Inicio Rapido página 12

Step 8
1
Pull the DRAWER FRONT BRACKETS (8G) apart and slide them into the grooves in the DRAWER SIDES (D44 and D45 ).
å
You may need to gently tap them in with a hammer.
NOTE: The DRAWER FRONT BRACKETS are marked "RH" and "LH" for easy identifi cation.
å
Fasten the DRAWER FRONT (G2) to the DRAWER FRONT BRACKETS (8G). Use four BLACK 9/16" LARGE HEAD SCREWS (1S).
å
2
U n fi
n i s h
s u r
f a c
e
D44
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D964) into the
å
grooves in the DRAWER SIDES (D44 and D45 )
and DRAWER FRONT (G2).
Page 12
G2
D44
With the palm of
your hand, tap
the DRAWER
BOTTOM down
into the groove.
e d
D964
G2
D45
VIEW THE T-SLOT BOX VIDEO
Push down
8G
D45
BLACK 9/16" LARGE HEAD SCREW
3
D158
D44
Fasten the DRAWER BACK (D158) to the DRAWER SIDES (D44
å
and D45). Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
Repeat this step for the remaining drawer.
å
423106
1S
(8 used in this step)
Start each screw a few turns before
completely tightening any of them.
30S
BLACK 1-9/16" FLAT HEAD SCREW
(8 used in this step)
Be sure the
DRAWER
BOTTOM
inserts into
D45
the DRAWER
BACK groove.
www.sauder.com/services