Bondioli & Pavesi SFT Manual Del Usuario página 21

If the clutch has four socket head set screws in addition to the eight hex
47
head bolts on the flange yoke, it is equipped with the Spring Release system.
Spring pressure is relieved when these four set screws are screwed into the flange
yoke. See the instruction leaflet enclosed with clutches with the Spring Release
system installed.
The Spring Release System enables checking of the condition of the friction clutch
and reduces spring pressure on the disks during storage.
Friction clutches equipped with the Spring Release System are supplied with
an additional instruction sheet. Read this information for proper use of the
Spring Release System.
Friction clutches may become hot during use. Do not touch!
48
Keep the area around the friction clutch clear of any material which could
cause a fire and avoid prolonged slipping of the clutch.
FNV - FFNV - FNT - FNK COMBINATION FRICTION AND OVERRUNNING CLUTCH
49
A clutch which combines the functional characteristics of friction clutch and
an overrunning clutch.
Used on machines with high inertial loads.
Lubricate every 50 hours of use and after storage.
Keep clear of the machine until all parts have stopped moving.
SHIELD DISASSEMBLY
Remove the Philips head screws.
50
Remove the base cone and the shield tube.
51
52 Remove the outer cone and the bearing ring.
SHIELD ASSEMBLY
Grease the bearing groove on inner yokes.
53
Fit the bearing ring into the yoke groove with the grease fitting facing the
54
drive tube.
Install the outer cone, inserting the grease fitting through the proper hole.
55
Install the base cone and shield tube.
56
Tighten the Philips head screws.
57
Use of electric powered screwdrivers is not recommended.
CV JOINT SHIELD DISASSEMBLY
58 Remove the screws arranged radially around the circumference of the CV
cone.
Remove the screws from the base cone.
59
Remove the base cone and the shield tube.
60
ENG
21