Bondioli & Pavesi SFT Manual Del Usuario página 22

ENG
Remove the CV cone.
61
Disengage the retaining spring, leaving it inserted in one of the two holes of
62
the bearing ring to avoid losing it.
63
Spread the bearing rings and remove from their groove.
CV JOINT SHIELD ASSEMBLY
Grease the bearing grooves.
64
Fit the bearing ring into the yoke groove with the grease fitting facing the
drive tube.
65 Install the bearing ring on the CV body with the reference pins facing the
inner yoke. The bearing ring is equipped with a grease fitting, used only for
50° CV joints. This grease fitting is not used with 80° CV joints.
66 Connect the retaining spring to the two edges of the bearing ring.
Slide the CV cone onto the CV body and align the radial holes with the be-
67
aring ring reference pins. Align the hole at the base of the CV cone with the
grease fitting on the smaller bearing ring.
In the case of 50° CV joints only: insert the shield strip, aligning with the
68
elements specified in point 66, and also the additional hole of the shield strip
with the grease fitting of the large ring.
Ensure that the radial holes of the CV cone are aligned with the holes on the
69
reference pins of the bearing ring.
In the case of 50° CV joints only: Ensure that the radial holes of the shield
70
strip are aligned with the holes on the reference pins of the bearing ring
and that the access hole on the CV cone is aligned with the grease fitting of the
bearing ring.
Tighten the 6 flange head screws of the protection strip. The use of an elec-
71
tric screwdriver is not recommended.
Fit the base cone and tube, inserting the grease fitting in the hole on the
72
base cone.
Tighten the 3 screws. Use of electric powered screwdrivers is not recommended.
73
SHORTENING THE DRIVELINE
Bondioli & Pavesi does not recommend modifications to its products.
74
If the driveline needs to be shortened, proceed as described below.
If you are unsure of the procedure, or need additional assistance, please contact
your local implement dealer or qualified service center.
Remove shielding.
75
22