Pull; Silver 3/8" Machine Screw - Sauder Adept Storage 418137 Instrucciones De Ensamblaje

Step 16
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the DOOR (G) to the HINGE UPRIGHT (D) as
å
shown in the lower diagram. Use the screws in the
HINGES. You should start each SCREW a few turns before
completely tightening any of them.
Fasten the PULL (53K) to the DOOR (G). Use two SILVER
å
3/8" MACHINE SCREWS (97S).
See the next step for DOOR adjustments.
å

SILVER 3/8" MACHINE SCREW

(2 used for the PULL)
Page 20
Stop
Mounting
screw
Hinge
97S
D
G
53K
418137
Pro Tip: Lift with your
legs. And, you know,
your arms.
B
www.sauder.com/services