Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
6. For non-ducted applications attach
the non-duct plate with four (4) M4
x 9.5 pan head screws. Make sure
power cord is behind plate. Fig. 17.
7. Attach the non-duct plenum box with
with four (4) M4 x 9.5 Pan Head
Screw. Fig. 18.
8. Place split bushing around power
cord and snap into non-duct plate.
Plug power cord into receptacle.
9. Take the hood body slide it in from
the front until it touches the wall, then
push the body upward to the ceiling
at desired location. Secure with the
six (6) mounting screws that were
removed previously in Step 3. Fig. 19.
10. Make the electrical connections:
a. Connect control box connector.
Fig. 20.
b. Connect lighting connector. Fig.
20.
c. Mount the sensor box. Fig. 20.
CONTROL
BOX
LIGHTING
CONNECTOR
SENSOR.
BOX
FIG.. 20
- 11 -
NON-DUCT
PLATE
M4. X. 9.5.
PAN. HEAD
SCREWS. (4)
M4. X. 9.5.
PAN. HEAD
SCREWS. (4)
NON-DUCT
PLENUM
BOX
HOOD
BODY
FIG.. 17
FIG.. 18
MOUNTING
SCREWS. (6)
FIG.. 19
Publicidad
Tabla de contenido
