Homeright PaintStick Manual De Instrucciones página 3

1. Hold the PaintStick at a 45°
angle and place the fill port
over the fill tube. Gently push
the PaintStick down until it
bottoms on the fill tube. DO NOT
KEEP PAINTSTICK ON FILL TUBE
FOR LONGER THAN 1 MINUTE
AT A TIME.
Troubleshooting
Problem: Air is drawn into the PaintStick instead of paint.
Solution: Slowly push handle in to expel air. Remove and reinsert PaintStick on fill tube. Be sure fill tube is fully seated in valve
body. If necessary apply petroleum jelly to fill tube which makes it easier to seat fill tube and valve body.
Problem: Difficult to insert or remove fill tube from port.
Solution: Put petroleum jelly in fill port opening and/or fill tube.
Problem: Handle is difficult to move in and out.
Solution: Lubricate inner tube o-rings (see CLEANING section).
Problem: Paint leaks out end cap.
Solution: Make sure end caps are flush with end on roller cover. If they are ok, remove end caps and reseal with petroleum
jelly (see CLEANING section).
Problem: Paint leaks out of fill port.
Solution: Lubricate valve port with petroleum jelly. If this doesn't work, replace valve kit (see parts drawing).
Painting with the PaintStick
• NOTE: Make sure the fill tube
is opposite from where you are
standing when filling to properly
seat the valve.
• NOTE: You may notice
petroleum jelly within the
PaintStick handle. This is
necessary and will help in its
operation and will not affect the
paint.
• NOTE: If inner handle is difficult
to pull out, hold the black knob
and twist inner handle, then pull.
PAINTSTICK
®
2. Pull inner handle all the
way back to draw paint into
PaintStick. Lift PaintStick slowly
off fill tube.
3
3. Push inner handle to feed paint
into the roller cover and start
painting.
If you are getting a dot pattern
when painting apply more paint.
If the roller is sliding apply less
paint.
ENGLISH