Intended Use; Scope Of Delivery - Bühler technologies AGF-PV-30 Guía Rápida

Ocultar thumbs

Contenido

página de 24

/ 24
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

AGF-PV-30, AGF-PV-S2, AGF-T-30, K-

AGF-PV-30, RAF-PV-30, ADF-PV-30

1 Introduction

This quick guide will assist you in starting up the unit. Follow

the safety notices or injury to health or property damage may

occur. Carefully read the original operating instructions in-

cluding information on maintenance and troubleshooting

prior to startup. These are located on the included CD and on-

line at

www.buehler-technologies.com

Please direct any questions to:

Bühler Technologies GmbH

Harkortstraße 29

40880 Ratingen

Germany

Tel.: +49 (0) 21 02 / 49 89-0

Fax: +49 (0) 21 02 / 49 89-20

These operating instructions are a part of the equipment. The

manufacturer reserves the right to change performance-, spe-

cification- or technical data without prior notice. Please keep

these instructions for future reference.

1.1 Intended Use

The filters were designed specifically for front panel installa-

tion in analysers or systems. All types can be used for filtering

sample gas.

When used in explosive atmosphere areas

Under certain conditions the filters and filter elements may

further be used in areas with explosive atmosphere. The pro-

visions and specifications in chapter "Use in explosive atmo-

sphere areas" must be observed in addition to the other spe-

cifications in these operating instructions.

1.2 Scope of delivery

• 1 x Filter

• Product documentation

2 Safety instructions

The equipment must be installed by a professional familiar

with the safety requirements and risks.

Be sure to observe the safety regulations and generally applic-

able rules of technology relevant for the installation site. Pre-

vent malfunctions and avoid personal injuries and property

damage.

The operator of the system must ensure:

• Safety notices and operating instructions are available

and observed,

• The respective national accident prevention regulations

are observed,

• The permissible data and operational conditions are

maintained,

• Safety guards are used and mandatory maintenance is

performed,

• Legal regulations are observed during disposal,

• compliance with national installation regulations.

Bühler Technologies GmbH

DANGER

Toxic, corrosive gases

The measuring gas led through the equipment can be hazard-

ous when breathing or touching it.

a) Check tightness of the measuring system before putting

it into operation.

b) Take care that harmful gases are exhausted to a save

place.

c) Before maintenance turn off the gas supply and make

sure that it cannot be turned on unintentionally.

d) Protect yourself during maintenance against toxic / cor-

rosive gases. Use suitable protective equipment.

WARNING

Fragile

Leaking toxic or explosive gasses may cause poisoning/injury.

a) Protect the equipment from external blows.

b) Protect the unit from falling objects.

3 Use in explosive atmosphere areas

Intended Use

AGF-PV-30. AGF-PV-S2, AGF-T-30. K-AGF-PV-30 and RAF-PV-30

filters may be used in Zone 1 and 2 areas with explosive atmo-

sphere. Explosion classes IIA, IIB and IIC are approved. The fil-

ters have no innate ignition source and do not fall into the ap-

plication of Directive 2014/34/EU and therefore do not bear

the CE mark.

The filters are marked as follows

Filter type

Marking:

AGF-PV-30