Hunter 82040 Manual Del Usuario página 14

Section E - Final Installation
E1
Fan Motor
Night Light
Light
*Option Fan & Main Light Together
E2
?
Install the wiring cover box. Make sure all wiring connec-
tions are inside the wiring cover box.
NOTE: Though this final installation section shows the housing mounted to a joist, the final installation procedure is the
E3
Connect fan wiring harness. DO NOT ALLOW THE FAN
TO HANG FROM THE WIRING HARNESS. INSTALLATION IS
EASIER IF TWO pEOpLE ARE INVOLVED.
42936-01 10/17/2007
Black
2 Pin
White
White
Red Night Light
3 Pin
Black Light
*Option
Connect the wiring as shown.
same whether the housing is mounted to a joist or suspended between joists.
Ground
Green
A
Black
Red
Black
E4
Install the fan assembly by inserting the tabs as shown
and pushing the fan assembly into the housing. Make
certain the wiring is not pinched between the fan assem-
bly and the housing.
14
Bare Copper
Main Switch 1 (AC In)
White
Switch 1 (AC In)
Switch 2 (AC In)