Hunter 82040 Manual Del Usuario página 2

TO REDUCE THE RISK OF ELECTRIC SHOCK OR INJURY, OBSERVE THE FOLLOWING:
1) Read all instructions before attempting to install or use this appliance. This appliance is for general
ventilating use only. Do not use this appliance for ventilating hazardous or explosive materials. Follow
the heating equipment manufacturer's guideline and safety standards, such as those published by
the National Fire prevention Association (NFpA), and the American Society for Heating, Refrigeration
and Air-Conditioning Engineers (ASHRAE), and the local code authorities. Use this appliance only as
described in this manual. Any other use not recommended by the manufacturer may cause
fire, electric shock, or injury to persons. SAVE THESE INSTRUCTIONS.
2) Before installing, servicing, or cleaning the unit, disconnect the power by turning off the circuit
breakers to the outlet box and associated wall switch location. If you cannot lock the circuit breakers
in the off position, securely attach a prominent warning device, such as a tag, to the service panel.
3) This unit must be grounded.
4) This appliance is not suitable for tub or shower installation, and must not be installed within a
minimum of 3 feet from the tub or shower opening. See Figure A.
5) Do not install this appliance lower than 7 feet (2.13 m) above the floor in the ceiling. See Figure A.
42936-01 10/17/2007
W A
NOTE: This illustration is not
to scale
Tub or Shower area
R N I N
Bath Fan
3 ft. min.
(0.91 m)
Figure A
2
G
7 ft. min.
(2.13 m)
Continued