Dogtra - Dogtra StB-Hawk Manual De Instrucciones

DESCRIPTION OF COLLAR PARTS
Red Dots
Activation Magnet
Magnet Activated Power/Mode Selection Switch
(Red Dot)
To activate the

dogtra

activation magnet to the red dot of the beeper
collar. Hold them together for a moment until
the LED indicator light comes on. A melody
will play when the unit is activated.
The dogtra StB-Hawk
Run/Point mode. To select a Point Only mode,
place the activation magnet to the red dot of the
beeper collar again for 0.5 to 1 second then
release.(First, the beeper collar has to be turned
on.) When a Point Only mode is selected, the
beeper collar will emit a hawk sound. If you
want to select a Run/Point mode again, repeat
the same procedure when you select a Point
28
StB-Hawk, place the
will always start in a
DESCRIPTION OF COLLAR PARTS
Only mode. When a Run/Point mode is
selected, the beeper collar will emit a double
beep.
To deactivate the dogtra
the activation magnet to the red dot of the
beeper collar. Hold them together until the
LED indicator turn to red. A melody will play
when the unit is deactivated.
StB-Hawk, place
29