Accessories - Dogtra StB-Hawk Manual De Instrucciones

CHARGING THE BATTERIES
Battery Charging Procedure
NOTE : The unit has a partial charge when it
leaves the Dogtra facility, upon receipt of the
collar, be sure to give it a full 2-hour initial charge
before the first use.
1. Attach the charging cable to the beeper
collar as shown on page 33.
2. Plug the charger into a 220-volt wall outlet
or, if using the accessory field charger, plug
into a cigarette lighter only for lithium-
polymer batteries. (Use a 110-volt charger
for U.S.A.). When properly plugged in, all
indicator lights should glow red. During the
charging process, the unit will shut off. Once
the battery cable is unplugged from the unit
after a full charge, you will need to turn the
unit on before use.
3. The battery is fully charged within 2 hours.
The lights will stay red during the charging
process. The red light will change into a
steady green light when the battery is fully
charged. (When you disconnect the charger
after finishing the charge, you will need to
restart the unit).
34
4. After charging, cover the battery charging
receptacles with the rubber plugs on the beeper
collar.
NOTE : Only use Dogtra-approved batteries,
chargers, and accessories for your Dogtra
collars. When a charger is not in use,
disconnect it from the power source.

ACCESSORIES

The following item may be purchased
separately.
Field Auto Charger
Designed for use with the 12-volt cigarette
lighter in your car.
ACCESSORIES
35