Sauder New Grange 419142 Manual Del Usuario página 8

Step 3
Turn the UPRIGHTS (E and F) over.
å
Separate the EXTENSION SLIDES (BB) from the
å
EXTENSION RAILS (AA) as shown in the upper diagram
below. Be prepared, the parts are greasy.
Fasten two EXTENSION RAILS (AA) to the UPRIGHTS (E
å
and F). Use four GOLD 5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into
å
the hole shown in the enlarged diagram. Then, slide the
innercartridge of the EXTENSION RAIL in to fi nd the other
hole that lines up with the hole in the UPRIGHT. Turn a
SCREW into this hole.
Open end
Finished edge
Page 8
BB
Push the black lever in and pull the SLIDE from the RAIL.
AA
F
GOLD 5/16" FLAT HEAD SCREW
AA
E
419142
3S
(4 used in this step)
AA
Open end
Finished edge
www.sauder.com/services