Installing The Transmitter - Kichler SOLA Manual De Instrucciones

INSTALLING THE TRANSMITTER

All wiring must be in accordance with the National Electrical Code and local
electrical codes. Electrical installation should be performed by a qualified
licensed electrician.
Select a location to install your wall mount control system transmitter. You can
replace an existing wall switch, or install the transmitter to a new outlet box.
NOTE: Make sure the electrical power is TURNED OFF at the main panel
before continuing.
NOTE: SWITCH INSTALLATION MUST COMPLY WITH ALL LOCAL AND
NATIONAL ELECTRIC CODE.
Step 1. Remove the existing wall plate and the old switch from the wall outlet
box. Wire nut the BLACK leads (hot) together and push back inside the outlet
box (Fig. 17) or select the desired location with a new wall outlet box.
Step 2. Use the screws provided to secure the wall transmitter to the outlet
box (Fig. 18).
Outlet box
Switch
Wall plate
Fig. 17
Outlet box
Wall switch
Fig. 18
SOLA | 15
Wall plate