Control System Set-Up - Kichler SOLA Manual De Instrucciones

CONTROL SYSTEM SET-UP

NOTE: Make sure the power is completely disconnected before you begin
this procedure.
Read all steps before proceeding. Each step must be followed exactly to
properly program the control system.
Step 1. Use a small flat screwdriver at the top or bottom of the switch plate to
gently pry apart the switch plate from the wall switch. Install the 12volt battery
included with the wall mount control system and make sure it is seated
correctly. Replace the switch plate (Fig. 19).
Step 2. Test the transmitter by pressing and releasing ANY button. A RED
light should illuminate. If not, check to make sure the battery is inserted and
seated correctly (Fig. 19).
NOTE: To prevent damage to the transmitter, remove the battery if not used
for long periods of time (months).
Step 3. You can leave the frequency switches at the factory setting.
However, if you are using more than one fan in the same area and want to
control them separately, you will need to change the dip switch settings in the
remote. Remove the battery and change the dip switch settings, assuring that
they are different from the other fans. Reinstall the battery and switch plate on
the control (Fig. 20).
16 | KICHLER.COM
Wall switch
Switch plate
Battery
Fig. 19
Code switch
Fig. 20