Installing The Transmitter - Kichler LUCIAN Manual De Instrucciones

Wall outlet box
Wall switch

INSTALLING THE TRANSMITTER

Wall plate
NOTE: All wiring and transmitter installation must be in accordance
with the National Electrical Code and local electrical codes. Electrical
installation should be performed by a qualified licensed electrician.
WARNING: Shut off main power at the circuit breaker or fuse panel
before continuing.
Select a location to install the transmitter and transmitter wall plate.
You can replace a pre-existing wall switch with the transmitter, or
Fig. 22
install the transmitter to a new wall outlet box.
Step 1. Remove the pre-existing wall plate and wall switch from pre- Wall outlet box
Transmitter wall plate
existing wall outlet box. Disconnect wires from switch. Wire nut the
BLACK leads (hot) together, and push wires back inside the wall outlet
Transmitter
box (Fig. 22). Or select a desired location with a new outlet box.
Screws
Step 2. Use the screws provided to install the transmitter to the wall
Screws
outlet box (Fig. 23).
Step 3. Use the screws provided to install the transmitter wall plate
(Fig. 23).
Fig. 23
52" LUCIAN LED | 17
TM