Installing The Transmitter - Kichler cULus 300285/85-GENT Serie Manual De Instrucciones

INSTALLING THE TRANSMITTER

Select a location to install the Wall Control System Transmitter and
Outlet box
Wall Plate.
CAUTION: Transmitter should NOT be mounted outdoors. Wall plate
Switch
Transmitter should be mounted indoors away from excessive heat
and away from contact with water or humidity.
Screws
Screws
Install the wall plate using an existing wall switch outlet box. Make
sure the electrical power is TURNED OFF at the main panel before
continuing.
If your ceiling outlet box has a ground wire (green or bare copper)
connect it to the ground wire from the wall switch and/or the ceiling
mounting bracket and push back inside the outlet box.
Install the wall plate on the existing wall outlet box using the screws
provided. (Fig. 21)
After installing the wall anchors, attach the wall plate with the
mounting screws to finish the installation.
Fig. 21
20
| KICHLER.COM