T Ools; W Orking Instructions; S Ervice /M Aintenance; P Reventive Maintenance - SUHNER ABRASIVE LXE 3-TOP Documentación Técnica

3.2 t
ools
Use only clean tools!
3.2.1 c /
hAnging fitting the tool
Hold spindle by wrench flats with open end wrench and
screw the tool.
3.3 w
orKing instructions
On failure of the compressed air release the valve lever!
To achieve an optimum grinding result, move grinding
wheel uniformly back and forth with light pressure. Exces-
sive pressure lessens the working capability of the ma-
chine, as well as the life of the grinding wheel.
4. S
ervIce
4.1 P
reVentiVe mAintenAnce
Without a tool clamped in check no-load speed
periodically and after each maintenance. Even if
the machine still operates perfectly, the motor
should be removed, cleaned and the four slides checked
for wear by a specialist after approx. 300 to 400 operating
hours. The lubricant in the gear head (Isoflex NBU 15)
should be replaced (do not wash out).
/m
aIntenance
13